Product Description INSTALLATION INSTRUCTIONS Terminal 30 to main battery 12V Terminal 87 to secondary battery or separate circuit 12V Terminal 85 to ground or -0V Terminals 86 is used for programming or override function OVERRIDE FUNCTION Connect terminal 86 through a momentary switch (not supplied) to terminal 30. When the switch is operated and the circuit is made the unit will make the connection between terminals 30 and 87 for 30 seconds from when the switch is released. PROGRAMMING FUNCTION To enter programming mode, the power must be off to terminal 30 and terminal 85 must be connected to ground or -0V. Connect terminal 86 to terminal 30 and then re-connect the power to terminal 30. The LED on the top of the unit will flash a number of times indicating the current programme number (once for 1, twice for 2, Etc.). Remove and replace, within 40 seconds, the connection to terminal 86 and the LED will start to sequence through the programme numbers (once for 1, pause, twice for 2, pause, Etc.). When the number of the programme required is reached remove the connection to terminal 86. The LED will flash the number of times to confirm the programme number selected. If this is OK re-connect terminal 86 and the LED will flash quickly indicating that the setting is saved. (If not OK turn the power off and start again.) Turn the power off. When the power is turned back on the unit will use the last programme set. SPECIFICATION Nominal Voltage………………………………….12V Maximum Voltage……………………………….16.5V Voltage Sensing…………………………………..Primary Battery Only Maximum Current……………………………….200A Standby Current………………………………….2mA Dimensions…………………………………………Please see dimensional drawing Weight ……………………………………………….140g Terminals…………………………………………….2 x M6 bolts 2 x 6.3mm blades
